ELECTRONICS

P Y R A M I D P O W E R

The Great Pyramids in Giza were said to have been covered in gold with a gold platinum capstone on Cheops, the central part of the circuit. Canals were found underground full of water. Shafts were found with metal connectors like plugins.

This subject I could go on for hours with, but to make this short and to the point for something everyone can build at home with minimal effort to use for heating, lighting, whatever, here is the skinny version...

The concept is so elementary, anyone with over half a brain can understand it.

Earth's core spits out charge at a rate of about 14 times a second, more or less. It was nearly 11 back in the 1980's. This is the force driving Schuman resonance. That kids, is a magnetic wave that bounces around earth inside the ionosphere and off the surface. What's interesting about this wave is that it acts quite differently between the air and the ground. In less or more dense matter, the wave will expand or contract based on what it travels through. So, if it travels through ferrous earth then suddenly meets the air, particles it uses to exist will begin moving differently than they do in earth ground.

So, a pyramid shape with a sharp peak , sealed from above as if water tight, given a metal seal, will pick up on the earth's low hz wave but not do this in phase with something buried in the ground. In other words, what we intend to do here is use the phase difference to generate power, and use some of that power to improve the potential of this circuit designed to bounce particles up and down with ever increasing intensity. In other words, by slowly opening spark gap, the phase relationship among the 2 separate grounds will cause energy to cross the gap if their is enough potential to cause that bridge. Enter the 3 copper plates attached to the grounding rod. Now you have 3 dielectric plates charging in parallel, and their vicinity will cause them to repel one-another. This causes a carried 3 phase wave to add onto earth's LF wave.

As any 3 phase wave attaches to a carrier wave (3x slower than itself, or 6 , or 9, etc...) the upper ground will naturally begin to get charged with one or the other pole due to the 3 phase wave relationship to itself reflecting back. There is one simple rule in magnetism; negative or positive prefer their opposites only. If a 3 phase wave implodes as 3 pulses with a carrier across spark gap, that's always going to cause the carrier to act as a 4th which forms what any electronic engineer will tell you, is a wave artifact. A 3/1 fractal. Given zero point, ie; a place to implosively focus, this fractal will manifest itself in anything willing to remove one of the poles off one of it's ends. Across spark gap, the positive moves down when negative moves up, so the real function of spark gap in this case is to split magnetic current to opposites more efficiently using this 3 pulse train. 3 pulses in turn act as a carrier to small waves yet. Those in metal as waves in the atoms themselves, but more easily in a copper winding made around a point of focus such as that grounding rod. 15 copper wire layers there will reflect 15 smaller waves during charge implosion as spark gap fires. These sinewaves riding on a carrier becomes pump z waves. It is known that pump z waves imploding in sync yet out of phase through a nonlinear medium must form a higher frequency. This is where the transformer that picks up off the LF earth modulation can play a part in generating power as well, not that it's necessary according to witness reports. Apparently this thing will make it's own juice simply by parting spark gap without additional carried wave reflection. This could be because of the atoms themselves providing surface tension on the 4 sided pyramid which resists the rotation of particles moving in and out of earth are in fact affected by the pulse train.

Whatever the case, I know of a fellow who built one of these pyramids not using tinfoil but a copper coil all the way to the apex ccw up, and it nearly killed him. As a word of warning; always keep the spark gap closed when nearing the device.

Exact specifications are unknown, but I'll test this in time and post results. These are supposed to work any size. There is even a tale of one that disappeared because it was ungrounded. Apparently, the grounding block needs to be heavy and I suggest not running it without a load! Wires leading from the device also keep this from literally disappearing in spacetime, because enough energy spilling off the apex will allow a natural magnetic water based ionosphere to form around it, even in the ground, and it will continue splitting charge until there is no more charge to split inside the ionosphere.